Melt Extrusion of High-Dose Co-Amorphous Drug-Drug Combinations

Research output: Contribution to journalJournal articleResearchpeer-review

Lærke Arnfast, Md Kamruzzaman, Korbinian Löbmann, Johanna Aho, Stefania Baldursdottir, Thomas Rades, Jukka Rantanen

PURPOSE: Many future drug products will be based on innovative manufacturing solutions, which will increase the need for a thorough understanding of the interplay between drug material properties and processability. In this study, hot melt extrusion of a drug-drug mixture with minimal amount of polymeric excipient was investigated.

METHODS: Using indomethacin-cimetidine as a model drug-drug system, processability of physical mixtures with and without 5% (w/w) of polyethylene oxide (PEO) were studied using Differential Scanning Calorimetry (DSC) and Small Amplitude Oscillatory Shear (SAOS) rheometry. Extrudates containing a co-amorphous glass solution were produced and the solid-state composition of these was studied with DSC.

RESULTS: Rheological analysis indicated that the studied systems display viscosities higher than expected for small molecule melts and addition of PEO decreased the viscosity of the melt. Extrudates of indomethacin-cimetidine alone displayed amorphous-amorphous phase separation after 4 weeks of storage, whereas no phase separation was observed during the 16 week storage of the indomethacin-cimetidine extrudates containing 5% (w/w) PEO.

CONCLUSIONS: Melt extrusion of co-amorphous extrudates with low amounts of polymer was found to be a feasible manufacturing technique. Addition of 5% (w/w) polymer reduced melt viscosity and prevented phase separation.

Original languageEnglish
JournalPharmaceutical Research
Volume34
Issue number12
Pages (from-to)2689-2697
ISSN0724-8741
DOIs
Publication statusPublished - Dec 2017

    Research areas

  • Journal Article

ID: 185403463