Microwave induced in situ amorphisation facilitated by crystalline hydrates

Research output: Contribution to journalJournal articlepeer-review

Documents

  • Tobias Palle Holm
  • Matthias Manne Knopp
  • Korbinian Löbmann
  • Ragna Berthelsen

Amorphisation within the final dosage form, i.e. in situ amorphisation, seeks to circumvent the potential stability issues associated with poorly soluble drugs in amorphous solid dispersions (ASDs). Microwave irradiation has previously been shown to enable in situ preparation of ASDs, when a high amount of microwave absorbing water was introduced into the final dosage form by conditioning at high relative humidity. In this study, an alternative to this conditioning step was investigated by introducing crystal water in form of sodium dihydrogen phosphate (NaH2PO4) di-, and monohydrate, in compacts prepared with 30 % w/w celecoxib (CCX) in polyvinylpyrrolidone K12 (PVP). As controls, compacts prepared with NaH2PO4 anhydrate and without NaH2PO4 were included in the study. The quantification of amorphous CCX after microwave irradiation showed an increase in CCX amorphicity for compacts containing NaH2PO4 di-, and monohydrate with increasing irradiation time. Complete amorphisation of CCX in compacts containing NaH2PO4 di-, and monohydrate was observed after 6 min, while no appreciable amorphisation was observed for the control compacts containing NaH2PO4 anhydrate and without NaH2PO4. Modulated differential scanning calorimetric analysis revealed that a homogenous ASD was formed after 12 min and 6 min for compacts containing NaH2PO4 di-, and monohydrate, respectively. Thermal gravimetric analysis indicated that NaH2PO4 monohydrate showed higher dehydration rates compared to the dihydrate, which in turn resulted in higher compact temperatures, and overall increased the rate of amorphisation and reduced the microwave irradiation time necessary to achieve a homogenous ASD. The present results confirmed the suitability of NaH2PO4 di- and monohydrate as alternative sources of water, the primary microwave absorbing material, for in situ microwave amorphisation. The use of crystalline hydrates as water reservoirs for in situ amorphisation circumvents the time-consuming and highly impractical conditioning step previously reported in order to achieve complete amorphisation. Additionally, it allows for easier and more accurate adjustment of the compacts water content, which directly affects the temperature reached during microwave irradiation, and thus, the rate of amorphisation.

Original languageEnglish
Article number105858
JournalEuropean Journal of Pharmaceutical Sciences
Volume163
Number of pages9
ISSN0928-0987
DOIs
Publication statusPublished - 2021

Bibliographical note

Publisher Copyright:
© 2021 Elsevier B.V.

    Research areas

  • Amorphous solid dispersion, Celecoxib, Hydrates, In situ amorphisation, Microwave radiation, Polyvinylpyrrolidone, Sodium dihydrogen phosphate

Number of downloads are based on statistics from Google Scholar and www.ku.dk


No data available

ID: 273633690